BZ-210-type three-cylinder piston pump pump seat assembly

BZ-210-type three-cylinder piston pump seat and plunger or copper sleeve is closely linked, then how do we assemble its pump seat it? BZ-210-type three-cylinder piston pump Assembly of the pump base 1, the rear bearing mounted on the eccentric shaft, and then the spring coil and the shaft has been installed in the shaft bearing into the bearing cover hole. 2, the pump cover and bearing cover closed, so that the pump foot down on the workbench. 3, from the three-cylinder, into the connecting rod, connecting the connecting rod and plunger piston pin hole alignment, into the plunger pin, the eccentric shaft rotation eccentric cylinder to the outside point, the copper sleeve Together with the O-ring mounted on the plunger, and then into the shaft seal ring and the middle sleeve. And load the other cylinder the same way. 4, the first pump body, so as not to install the front bearing, double-end cap sprang from the copper sleeve. 5, into the front bearing and double cover. Industrial Internet (Xiamen) Technology Co., Ltd. Asia Pump Network Editor: He Daohui (QQ / WeChat:) http://beng.liuti.cn/ (Service Hotline:)